Electrovoice xld8/25/2023 Stainless steel with powder coat paint and hydrophobic clothĩ.9 in x 28.58 in x 14.52 in (251 mm x 726 mm x 369 mm)ġ Full Space Measurement of four (4) elements.Ģ Full Space Measurement of HF section of four (4) elements, SPL adjusted for 1 m distance.ģ Use EV signal processing or download presets from Electro-Voice website. X-Line Very Compact weatherized models deliver unprecedented performance in outdoor venues in full exposure.įully Captive Aluminum, 1° increments, 16 elements with 8 to 1 Safety FactorĢ00W Cont., 800W Peak LF2 - 200W Cont., 800W Peakġ3-ply plywood with fiberglass and EVCoat LAPS2 modeling software quickly provides array configurations and rigging information. The XCS312-FG subwoofer module can be directly arrayed above, or below XLD281-FG full-range systems. XLVC provides three methods to conveniently do this. Most applications using flown very compact elements require subwoofers integrated into the same array as the full-range systems. The single-woofer versions include the XLE181-FG with a 120° horizontal coverage pattern and the XLE191-FG with a 90° horizontal coverage pattern. The dualwoofer versions include the XLD281-FG with a 120° horizontal coverage pattern and the XLD291-FG with a 90° horizontal coverage pattern. The XLVC weatherized family consists of two full-range systems with dual woofers, two full-range systems with single woofers and a subwoofer system. Integrated rigging with hinge points located correctly between array elements is simple to use and quickly provides uncompromised line array performance. The XLD281-FG can be used in tri-amp mode, or in bi-amp using a sophisticated internal passive network.ĭesigned for use in arrays of four or more elements, the XLD281-FG delivers full bandwidth audio with precise, predictable coverage control. The FG models are fully-weatherized and fiberglass-coated. CCT uses both 8 inch transducers to provide maximum low frequency output and operating bandwidth while controlling horizontal beam width to 200 Hz by using DSP. It uses an 8 inch neodymium LF transducer, an 8 inch neodymium LF/MB transducer, and two neodymium 2 inch voice coil compression drivers combining through 2 hydra plane wave generators into a 90° x 10° waveguide. It uses an 8 inch neodymium LF transducer, an 8 inch neodymium LF/MB transducer, and two neodymium 2 inch voice coil compression drivers combining through 2 hydra plane wave generators into a 120° x 10° waveguide. The XLD291-FG is a 3way design using CCT (Coverage Control Technology) to control horizontal coverage to 200 Hz. The XLD281-FG is a 3-way design using CCT (Coverage Control Technology) to control horizontal coverage to 200 Hz.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |